Forum > Modifications
Hoofies Mk2 How To
Jason:
I have finally done the how to for the new MK 2 Hoofies (bolt-on) so here it is
First here is the kit that you will get ( note the hole names ) once the hoof wears you can turn it round and use the rear as the front and double its use
Oh and if anyone wants to do this with their own rubber "Go For It" it should work so long as you get the rubber thickness right
Jason:
Next you have to remove the hoof by undoing the 4 bolts marked below
Jason:
You will now have 1 rubber hoof, 4 bolts and 4 lockwashers as below I have seperated the lockwashers from the bolts as these will be reused later
Jason:
Now take 4 of the studs from the kit and screw them into the 4 holes in the hoof
Before you screw them in have a look at how deep the hole in the hoof is as you want them to go to the bottom but not distort the hoof
Jason:
Take 4 nuts from the kit and put one on each stud run them down to the bottom and tighten with an 8mm spanner not to tight just enough to lock the studs in place
Navigation
[0] Message Index
[#] Next page