Pro-Jump PowerBocking Jumping Stilts Forum - Community for Power bocking / Pro Jumping!
YOUR JUMPING STILTS => Problems and solutions => Topic started by: conn on May 20, 2009, 08:30:11 PM
-
hey there anybody i purchased my powerizers and i was fine till i fell i hurt my knee and my knee bar (old version) became loose if anyone has the old model of knee bar the way the strap is kept tight at the side is by two backles i set my strap the way it should be to keep tight but it becomes loose from having two buckles it just goes into one afterwards any help please so i can get on ??? help would be aprecated :)
-
Hi conn, can you post a picture of it?
-
Sounds like you stretched one of the buckles (they are like the D-rings you get on motorbike helmets) but they arn't welded shut sometimes and when you give them a really good pull one pops over the other and it comes loose
Have a good look at them and if one is bigger you can shut it again with a big pair of pliers
Otherwise are you sure you are doing it up right as it is easy to thread them wrong
Jason :Hoofies2: :CGEEK:
-
yea there both the same size and i do thread them properly
-
i dont know alot about knee bars but some people like the calf cuff's better
(i know i do hehe) :Ctongue:
-
Stick a few pics up and try to do one of when you first do them up and one when it ends up through just one ring
That way we might be able to figure it out as the only way it can go from threaded through 2 rings to threaded through 1 is for one ring to pass through the other which normally happens when one ring has been distorted
Jason :Hoofies2: :CGEEK: