Pro-Jump PowerBocking Jumping Stilts Forum - Community for Power bocking / Pro Jumping!

YOUR JUMPING STILTS => Problems and solutions => Topic started by: mandy077 on October 21, 2010, 11:19:51 AM

Title: Adjusting the Supporting Rods
Post by: mandy077 on October 21, 2010, 11:19:51 AM

 after some advice bout my RT boot its  def the supporting rods,i did play around with them and it was fine but after a few jumps went straight back to the way it was.  the end result is part under my foot plate is sticking out and my knee is goin the other dircetion. and i cnt even walk on them. 

 thanks guys x

Title: Re: Adjusting the Supporting Rods
Post by: webmaster on October 21, 2010, 12:02:14 PM

Hi there try the following tutorial by Jason http://www.projumpforum.co.uk/index.php?topic=2337.0

Also make sure that the nut at the end of the support rod is still there (See attached pic)

Title: Re: Adjusting the Supporting Rods
Post by: webmaster on October 21, 2010, 02:23:04 PM

Quote from: mandy077 on October 21, 2010, 02:13:08 PM

also i notice ive lost one of the bottom nuts  on the LT hand side. im of to get another one.

Hopefully this will solve it

Title: Re: Adjusting the Supporting Rods
Post by: Jason on October 21, 2010, 07:08:29 PM

That missing nut will cause the bocks to be totaly unusable

Don't just pop it on and get back on them make sure you loosen all the bearing bolts and pull the stilt straight after following the set up that naz recomended

Shame you couldn't make it on saturday as I could have got them straight for you

Good luck

Jason  :Hoofies2: :CGEEK: